UPA120-180 P.PUMP FOR 1 SHWR 0.37HP W/O FLOW SWITCH - SUNDRY - ( - GRUNDFOS - 0x0 mm - 0inchx0inch )

Materials

• Pump housing Cast iron EN 1561 EN-GJL-150
• Impeller Composite PP-GF30
  
• Range of ambient temperature - 0 .. 40 °C
• Maximum operating pressure -10 bar
• Pipe connection standard - ISO 228-1
• Max. power input - 250 W
• Mains frequency - 50 Hz
• Rated voltage - 1 x 230 V
• Maximum current consumption - 1.14 A
• Installation - Horizontal shaft mounting recommended; automatic operation (requires external flow switch)
• Noise Level - Low-noise design
• Operating Temp.Up to 95 °C (hot/cold water service)
  

Regular Maintenance:-

• Inspect for leaks: Check all pipe connections and fittings regularly for any signs of water leakage
• Clean the pump exterior with
  a dry or slightly damp cloth. Avoid water entering the motor housing.
• Check for unusual noise or vibration: This can indicate debris buildup or wear and tear.
  
  Electrical Safety:-
• Disconnect power before servicing the pump or performing any maintenance.
• Make sure the power cord and plug are dry and undamaged at all times.
• Avoid using extension cords or damaged sockets.
  
  Water Quality:-
• Ensure that clean debris-free water is supplied to the pump.
• Install a if the water supply has sediment, to prevent internal wear or clogging.
  
  Operational Tips:-
• Do not run the pump dry. Always ensure there’s water in the pipeline before switching it on.
• If the pump is not used for an extended period, switch it off and drain the water if necessary.
• Operate only within the specified temperature range (up to 95°C) and pressure limit (10 bar).